Track Wheels and TPMS

[Jo0]

I know I can get TPMS readings from Carista. It's on the same page before I enter the IDs for my second set of wheels

[timurrrr]

Originally Posted by RedReplicant

How are you getting that?

I didn't say I was able to do get that not yet, at least.

But I'm convinced it's possible. The question is how...
See this thread: https://www.ft86club.com/forums/showthread.php?t=113385
and this post:

Originally Posted by BRZyJ

Guess not...I got off my ass and mailed mine in for the latest firmware and it came back this morning. Works using the first set of codes from the link in the previous post (2013 BRZ).


pressure/temperature:

Originally Posted by RedReplicant

These are the channels I've got in AIM.

Well, if AIM doesn't have a definition for a data channel it doesn't mean the data channel doesn't exist!

[geraldjust]

Originally Posted by timurrrr

I didn't say I was able to do get that not yet, at least.

But I'm convinced it's possible. The question is how...
See this thread: https://www.ft86club.com/forums/showthread.php?t=113385
and this post:




Well, if AIM doesn't have a definition for a data channel it doesn't mean the data channel doesn't exist!

yup it's possible. i did it with my custom gauges i make. When to a autocross event and notice how much i needed them to be checking the tires as you do more runs they tend to warm up. and your PSI starts increasing. So i made mine also check temp too. it actually updates fairly often when the wheels are rotating, around 10-15 sec depending how fast your going. if yours stopped its around 30 sec update time. When car doesn't move for more than 5 min then the sensors only update every 2-5min, unless it starts to move again.

the data doesn't tell you what wheel is what though. since it goes from ID1 though 4. theirs no way to tell if its front left or right etc. The wireless receiver downs know what wheel is were. only reads the wireless signals. its a good thing to keep track of if you want.