WHAT DID YOU DO TO YOUR FRS TODAY?

[WNDSRFR]

Originally Posted by DarkPira7e

You'll be calling it plenty of things if you round that head even the smallest bit

Yeah
I got my e10 socket and it doesn't fit. It fits on the passenger seat because I didn't try to remove them with the wrong tool. Looks like I need to get some really sharp cobalt drill bits and try to drill them out. G.D.M.F. pieces of S.

[blsfrs]

While checking my FRS over for next weekend's HPDE event at Summit Point, I found some pretty deep cracks in my right front rotor. The left didn't look too bad. I changed them both.

[bcj]

Ouchy!

[Ultramaroon]

That's impressive.

[Ultramaroon]

Good enough. Start the clock.

[gt86ser]

Finally installed Bayson's R Trd style lip on my 2015, yes it does fit, took the chance on it.

[WNDSRFR]

Some people never learn. I rounded out the bolts holding the driver's seat down making them virtually impossible to remove by using the wrong tool The first one I drilled and removed with a medium easy-out. It wasn't easy but it worked. The torque on these bolts is unbelievable. I thought I was going to break the vice grip holding the easy-out.
The second bolt, I figured, I could do a shortcut and drill the hole smaller and use a smaller easy-out. So, of course the worst possible thing happened. The easy-out broke in the hole. I don't know what I'm going to do now.
I can't believe what kind of idiot would use this fastener for this application. It's an M10 bolt with a tiny little head on it torqued down to a million ft/lbs.
I hope the guy got fired and now works at the VW design department where is opinions are cherished.

[Ohio Enthusiast]

Originally Posted by WNDSRFR

It's an M10 bolt with a tiny little head on it torqued down to a million ft/lbs.

To be frank it's only torqued to 39 ft-lb.
There are rounded nut extractors that you should still be able to use - they look like a regular socket with a left-handed twist in them. Some penetrating oil wouldn't hurt, either. Project farm did a test on these once, he's my go-to place for recommendations -

[WNDSRFR]

It might have been torqued down to 39 ft/lbs but it takes a hell of alot more force than that to remove them. Thanks for the tip on the nut extractors. Maybe that'll do the trick. As far a penetrating oil. They've been marinading for a month.

[Ultramaroon]

The black oxide anti-corrosive finish is notorious for stiction. That and the wide flange are a horrible combination.

[WNDSRFR]

Outstanding description of the situation. At least they corrected the problem.

[SuperSub7]

Originally Posted by gt86ser

Finally installed Bayson's R Trd style lip on my 2015, yes it does fit, took the chance on it.

Nice!

[gt86ser]

Installed Bayson R Trd style fender flare extensions today.

[whataboutbob]

SMOG