My exhaust is tilted

[gpvecchi]

My left pipe leans out more than my right one.
Do you know how to make them even?
Thank you!

[humfrz]

Originally Posted by gpvecchi

My left pipe leans out more than my right one.
Do you know how to make them even?
Thank you!

I suggest you place a piece of pipe in one of them, then heat up the last bend in the tail pipe with a torch, then push/pull on the piece of pipe till the tail piece it is where you want it to be.

Bubba says just to stick a two foot long piece of waterpipe in the offending one, stick your foot up against the muffler and yank on it till it's straight.

[RToyo86]

Could just be your exhaust setup needs some adjustments. The Corsa system I ran had a similar issue I could fix by rotating the midpipe section slip joints up/down which effected the alignment of how far the one side poked.

[gpvecchi]

Originally Posted by RToyo86

Could just be your exhaust setup needs some adjustments. The Corsa system I ran had a similar issue I could fix by rotating the midpipe section slip joints up/down which effected the alignment of how far the one side poked.

Thanks, I prefer to try some adjustments than heat up some parts. I don't think that stock midpipe has slip joints, right?

[bcj]

The mounting flanges may have been manufactured or knocked cattywompus.

:/

[gpvecchi]

FYI, I passed awhole afternoon loosing all the parts of the exhaust and adjusting them.
Absolutely no difference.

[2020BRZtS]

My thought was the rear hangars not being centered on their post.

[gpvecchi]

The only way to correct is to bend them, with the risk of snapping them...

[tomm.brz]

mine too, no solution

[humfrz]

Originally Posted by gpvecchi

The only way to correct is to bend them, with the risk of snapping them...

Heck, your exhaust pieces aren't made out of glass ...... are they?

OK, here is the humfrz method. Take your car up to a muffler shop and tell them how you want them to look. Sit back in the customer lounge and read part of a car magazine. When they are finished, inspect them to make sure they are the way you want them. Pay them, don't worry about how much it costs - the job is done - right? Go home, have a beer and take a nap.

[humfrz]

Originally Posted by tomm.brz

mine too, no solution

Oh, really?

Allow me to introduce you to Bubba's favorite tool -

[gpvecchi]

Originally Posted by humfrz

Heck, your exhaust pieces aren't made out of glass ...... are they?

OK, here is the humfrz method. Take your car up to a muffler shop and tell them how you want them to look. Sit back in the customer lounge and read part of a car magazine. When they are finished, inspect them to make sure they are the way you want them. Pay them, don't worry about how much it costs - the job is done - right? Go home, have a beer and take a nap.

Muffler shops? There nothing like that in Italy...

[nextcar]

Originally Posted by gpvecchi

Muffler shops? There nothing like that in Italy...

Ahh Italy, such great memories... such a beautiful country!

But as I recall from all the magnificent statues, one side always hangs a little lower than the other!

[gpvecchi]

Thank you very much for your appreciation! Unluckily Italy is a beautiful place, stuck in bureaucracy and corruption...
Every exhaust has to be ECE approved, so muffler artisans are out of the market...