Hooker Blackheart Axle-back Dual Exhaust w/ Mufflers

[humfrz]

Originally Posted by celek

They save every bit of money they can, ever since they have gone under the Holley conglomerate umbrella everything is outsourced to China. They have major quality and fitment issues warping of flanges, flaking of coatings, cheapest possible gasket material on other parts. I hope it is not the same here.

By reading this thread I see a bit of tweaking needed to get fitment right. twisting of the exhaust then clamp and hangers for alignment. Not including a flange takes the precision out of manufacturing and handed over to the installer.

There ya go. Yep, back-in-the-day ....... we found that some flex pipe, muffler seal and a few clamps would fix any exhaust system .......


humfrz

[jeepmor]

Looks like they have their fitment issues sorted. Speed Academy said it was about the easiest exhaust they've ever done and it tucked up nicely for the low rider crowd.

I found this thread because I did like the sound it produced, didn't seem raspy or sharp and was fairly tame sounding. What I'm after.

8:00 minutes is where exhaust starts. Doesn't look like this OP is stainless model, not sure. Also, this version in vid has it's own resonator.

[DQR]

Thank you very much for posting the video. I've been looking for months of a in car video featuring this exhaust.