Cosworth Supercharger Owners Thread

[Hamegreg]

I have been looking for the 1.X power stages lately and can't seem to find them anymore... nameless is not selling them anymore and Rallysportdirect seems to say that they are discontinued. Any words ?


Sent from my iPhone using Tapatalk

[sly]

Originally Posted by Hamegreg

I have been looking for the 1.X power stages lately and can't seem to find them anymore... nameless is not selling them anymore and Rallysportdirect seems to say that they are discontinued. Any words ?

You can still order from part-box: https://www.part-box.com/?route=prod...r=ASC/limit=30


Just tell them that they are unavailable in the US and they should ship to you. I bought my 0.2 midpipe from them.

[weederr33]

Originally Posted by Hamegreg

I have been looking for the 1.X power stages lately and can't seem to find them anymore... nameless is not selling them anymore and Rallysportdirect seems to say that they are discontinued. Any words ?


Sent from my iPhone using Tapatalk

I believe the catback has been discontinued, as for the front pipe, part-box should have one. And I know FT86SpeedFactory has a few of the Cosworth headers in stock, too.

[Hamegreg]

Originally Posted by sly

You can still order from part-box: [...]

Just tell them that they are unavailable in the US and they should ship to you. I bought my 0.2 midpipe from them.

Thanks for the info, how much did that set you back (shipping wise)?


Sent from my iPhone using Tapatalk

[sly]

Originally Posted by Hamegreg

Thanks for the info, how much did that set you back (shipping wise)?

£99.00 or ~$125. Their prices are lower that what they were in the US. So even with shipping, it ended up costing almost $200 less that what I could have gotten here.

[Hamegreg]

Originally Posted by sly

£99.00 or ~$125. Their prices are lower that what they were in the US. So even with shipping, it ended up costing almost $200 less that what I could have gotten here.

I'll definitely look into then !
Thanks a bunch


Sent from my iPhone using Tapatalk

[pjp]

Doe's Cosworth have a high pressure cap for the Twins??

[weederr33]

Originally Posted by pjp

Doe's Cosworth have a high pressure cap for the Twins??

To my knowledge they don't. Which is sad

[sly]

No. I actually bought one that was listed as fitting the BRZ but it doesn't. It fits the WRX.

They make brakes, an oil cap, radiator hoses, supercharger, exhaust, air filter and a low temperature thermostat. Most of them are being discontinued though.

[weederr33]

Originally Posted by sly

No. I actually bought one that was listed as fitting the BRZ but it doesn't. It fits the WRX.

They make brakes, an oil cap, radiator hoses, supercharger, exhaust, air filter and a low temperature thermostat. Most of them are being discontinued though.

That's a shame. Wish they would offer more goodies.

[pjp]

TRD has a cap any others?
And Yes to more Goodies !!!!

[pjp]

With the Supercharger install did any one add gauges?
Type and installed ware??

[weederr33]

Originally Posted by pjp

With the Supercharger install did any one add gauges?
Type and installed ware??

I haven't done any gauges yet, but I do have one of those OBDII bluetooth readers for the Torque App and it gives good enough info. I mostly care about oil temperatures, but it does more than that.

[muckypuppy]

Originally Posted by pjp

With the Supercharger install did any one add gauges?
Type and installed ware??

I have the P3Cars vent gauge that covers pretty much everything except oil pressure. Reads from the OBD11 port. Downside to this gauge is that you have to manually scroll through to get info. I normally use it to read either boost or intake temps. I also have defi racer oil pressure and oil temp gauges on the dash in a Block8head dual pod so I can keep an eye on those a bit better while driving. The sensors are connected to a TRD sensor sandwich plate.