|
||||||
| Electronics | Audio | NAV | Infotainment Anything related to in-car electronics, navigation, and infotainment. |
 |
|
|
Thread Tools | Search this Thread |
01-07-2017, 09:55 AM
|
#1 |
|
Junior Member
Join Date: Dec 2016
Drives: 2013 FR-S
Location: Dallas
Posts: 8
Thanks: 0
Thanked 1 Time in 1 Post
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
FT601US in FRS
I've searched everywhere, and still have one unanswered question.
I put a FT601US from a BRZ in my FRS, both 2013. Everything works, except the radio. The only thing I haven't found is WHERE the wire from pin 8 needs to connect to. Does anyone know? |
|
|
|
01-07-2017, 07:33 PM
|
#2 |
|
Junior Member
Join Date: Dec 2016
Drives: 2013 FR-S
Location: Dallas
Posts: 8
Thanks: 0
Thanked 1 Time in 1 Post
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Trying to power the antenna booster. The FRS antenna connector has one large wire for the antenna, and a smaller wire in the plug.
Running a jumper from pin 8 on the gen pin connector will supply 12v when the HU is in FM/AM/SAT modes, but I haven't found where the other end of the jumper goes. |
|
|
|
|
01-09-2017, 08:38 PM
|
#3 |
|
Senior Member
Join Date: Jul 2012
Drives: 2023 WRB BRZ (MT)
Location: Coral Springs, SoFlo
Posts: 2,252
Thanks: 1,503
Thanked 534 Times in 430 Posts
Mentioned: 42 Post(s)
Tagged: 5 Thread(s)
|
There's a post somewhere I used when I did it. I believe I just tapped into the ACC wire so as long as radio is power it is good to go
|
|
|
|
|
01-09-2017, 08:46 PM
|
#4 |
|
Senior Member
Join Date: Jul 2012
Drives: 2023 WRB BRZ (MT)
Location: Coral Springs, SoFlo
Posts: 2,252
Thanks: 1,503
Thanked 534 Times in 430 Posts
Mentioned: 42 Post(s)
Tagged: 5 Thread(s)
|
" you would need to add a new pin/wire at pin #8 on your car's 10-pin power/speaker plug, and tie that to the smaller single wire (not the coax antenna cable) on your car's AM/FM plug."
That's what I did |
|
|
|
|
|
|
|
|
|
|
