Innovate (Sprintex) Supercharger Owners Topic - Page 505 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

riboyster · 04-20-2016, 01:58 PM

Quote:

Originally Posted by SlowShifter

Does anyone have any recommendations for me in regards to attempting to clean up the fuel system before I go to the effort of replacing the spark plugs and other things? Would spraying pure ethanol (or anything) into the throttle air intake help or hinder? I'm basically looking for anything "easy" to attempt before I go full scale on my main stuttering issue after I fix this leak.

I said it earlier: try seafoam and fuel injector cleaner additive.

Rifle · 04-22-2016, 08:03 PM

So about a month ago I told Sprintex I thought my intercooler pump might be going, I noticed it starting to leak. They were awesome with the warranty and sent me out a replacement. I scheduled a dyno for today, and completely forgot about the intercooler pump issue (it's sitting in my garage). One run on the dyno and the car wouldn't let me go past 10 degrees of timing.. (tuned down 2 degrees and the knock correction 3 degrees).. so in total, I was 5 degrees of timing out... At first we thought it could be a false read.. but then we decided to feel the intercooler. It was ice cold..

Just to go further with that, I then had to drive 3 hours home, and after parking, the intercooler is luke warm at best. So, silly me, now has to change the intercooler pump.. (WHICH I SHOULD HAVE DONE AWHILE AGO).. gonna flush the whole system too, just to make sure it's not airlocked or anything.

#issues

riboyster · 04-22-2016, 09:44 PM

On the bright side, you won't do that again!

Chad86 · 04-23-2016, 08:55 PM

I'm ready to configure my tune with Moto-East, but I have a few questions about map selection and the different options.

Are the map options always ON with the set map or can you disable/enable them on the specific map at any time?

How do you enable the valet mode option?

stockysnail · 04-24-2016, 02:54 AM

Quote:

Originally Posted by Chad86

I'm ready to configure my tune with Moto-East, but I have a few questions about map selection and the different options.

Are the map options always ON with the set map or can you disable/enable them on the specific map at any time?

How do you enable the valet mode option?

You can have up to 4 maps which can be changed with your cruise control switch. If a map has something like flat foot shifting, it will be always on. Auto blip only occurs during certain circumstances. I prefer to not have any of those features and do them all myself, thus my tune doesn't have any of those. I forgot how to turn on valet mode, but should be searchable on Google or whatnot.

riboyster · 04-24-2016, 05:24 AM

I'm pretty sure valet mode has to be enabled by your tuner on one of the maps. I have mine in 3rd map

Kodename47 · 04-24-2016, 08:18 AM

There is no real "valet" mode, it's just something that can be configured into one of the map modes.

walletsr · 04-24-2016, 12:05 PM

I putting a feeler out there to see if anyone is interested in the sprintex 335 kit with the intercooler. I am pretty set on going a different route.

riboyster · 04-24-2016, 06:54 PM

Quote:

Originally Posted by walletsr

I putting a feeler out there to see if anyone is interested in the sprintex 335 kit with the intercooler. I am pretty set on going a different route.

What's the reasoning? Also what kinda price for just the intercooler?

camelflage · 04-25-2016, 02:11 AM

ordered a 210 thursday. :woot:

riboyster · 04-25-2016, 04:21 AM

Quote:

Originally Posted by camelflage

ordered a 210 thursday. :woot:

You installing it yourself?

camelflage · 04-25-2016, 09:08 AM

Quote:

Originally Posted by riboyster

You installing it yourself?

Nope. I've gotten lazy in my old age so I'm having the shop install and dyno tune.

Sent from my HTC6500LVW using Tapatalk

walletsr · 04-25-2016, 09:49 AM

I will only sell intercooler separately if someone wants the 335 only. I think I snapped a rod not sure what the exact issue was I dropped my car off at the engine builder Saturday. I know there is a hole due to the chunks of metal I found.

Chad86 · 04-25-2016, 11:24 AM

How difficult is it to load the EcuTek tune? I assume you just plug in with your laptop and run the ProECU software to load the file.

Does the tune need to be loaded prior to the shop starting the car the first time?

04-22-2016, 08:03 PM	#7058
Rifle EX-86 Supercharged God Join Date: Aug 2015 Drives: '16 Series.HyperBlue BRZ Location: Philadelphia->Montana Posts: 766 Thanks: 220 Thanked 479 Times in 253 Posts Mentioned: 16 Post(s) Tagged: 1 Thread(s)	So about a month ago I told Sprintex I thought my intercooler pump might be going, I noticed it starting to leak. They were awesome with the warranty and sent me out a replacement. I scheduled a dyno for today, and completely forgot about the intercooler pump issue (it's sitting in my garage). One run on the dyno and the car wouldn't let me go past 10 degrees of timing.. (tuned down 2 degrees and the knock correction 3 degrees).. so in total, I was 5 degrees of timing out... At first we thought it could be a false read.. but then we decided to feel the intercooler. It was ice cold.. Just to go further with that, I then had to drive 3 hours home, and after parking, the intercooler is luke warm at best. So, silly me, now has to change the intercooler pump.. (WHICH I SHOULD HAVE DONE AWHILE AGO).. gonna flush the whole system too, just to make sure it's not airlocked or anything. #issues __________________ Sprintex 210 Supercharged HyperBlue BRZ "HI MOM" 295WHP/220TQ

04-22-2016, 09:44 PM	#7059
riboyster Senior Member Join Date: Aug 2015 Drives: 2013 Scion FRS Location: Maui, HI Posts: 387 Thanks: 143 Thanked 112 Times in 95 Posts Mentioned: 2 Post(s) Tagged: 0 Thread(s)	On the bright side, you won't do that again! __________________ ScreamingElectron - SnakeShit

04-24-2016, 05:24 AM	#7062
riboyster Senior Member Join Date: Aug 2015 Drives: 2013 Scion FRS Location: Maui, HI Posts: 387 Thanks: 143 Thanked 112 Times in 95 Posts Mentioned: 2 Post(s) Tagged: 0 Thread(s)	I'm pretty sure valet mode has to be enabled by your tuner on one of the maps. I have mine in 3rd map __________________ ScreamingElectron - SnakeShit

04-24-2016, 08:18 AM	#7063
Kodename47 Senior Member Join Date: Oct 2012 Drives: UK GT86 Location: UK Posts: 3,040 Thanks: 185 Thanked 1,632 Times in 1,113 Posts Mentioned: 156 Post(s) Tagged: 1 Thread(s)	There is no real "valet" mode, it's just something that can be configured into one of the map modes. __________________ .: Stealth 86 :. Abbey Motorsport/K47 Tuned Sprintex 210 Supercharger Kodename 47 DJ: Soundcloud / Instagram / Facebook

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Innovative ideas to increase interior storage capacity?	swift996	Cosmetic Modification (Interior/Exterior/Lighting)	0	01-30-2013 11:45 PM
AVO vs Innovative	diss7	Forced Induction	32	01-21-2013 07:15 PM
Not another need to drive topic	Sargy	Mid-Atlantic	5	11-27-2012 01:18 PM
Technical topic sub-forums	OrbitalEllipses	Site Announcements / Questions / Issues	1	07-18-2012 12:38 AM
Can you close the topic please?	Standardsuspension	Brakes, Suspension, Chassis	14	06-26-2012 06:14 PM

04-24-2016, 12:05 PM	#7064
walletsr Member Join Date: Aug 2014 Drives: 2014 Location: Minneapolis, MN Posts: 78 Thanks: 0 Thanked 13 Times in 11 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	I putting a feeler out there to see if anyone is interested in the sprintex 335 kit with the intercooler. I am pretty set on going a different route.

04-25-2016, 02:11 AM	#7066
camelflage Senior Member Join Date: Jul 2012 Drives: pinto power Location: Sterling, VA Posts: 709 Thanks: 76 Thanked 192 Times in 136 Posts Mentioned: 8 Post(s) Tagged: 1 Thread(s)	ordered a 210 thursday. :woot:

04-25-2016, 09:49 AM	#7069
walletsr Member Join Date: Aug 2014 Drives: 2014 Location: Minneapolis, MN Posts: 78 Thanks: 0 Thanked 13 Times in 11 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	I will only sell intercooler separately if someone wants the 335 only. I think I snapped a rod not sure what the exact issue was I dropped my car off at the engine builder Saturday. I know there is a hole due to the chunks of metal I found.

User Name		Remember Me?
Password