WHAT DID YOU DO TO YOUR BRZ TODAY? - Page 943 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

kberkel · 12-05-2015, 01:31 AM

Quote:

Originally Posted by spicyricecake

any chance you'd make a small run of blue stitched ones??

I'd have to find a good color match, so not sure yet, but maybe in the future.

I think I am switching to a better material too.. just waiting on samples. I'll let you know.

Tcoat · 12-05-2015, 01:44 AM

Quote:

Originally Posted by Spinning Sushi

A random bucket appeared and attacked my front lip on the freeway while I was doing about 65-ish...

Then I fixed it the next day with random stuff I had around.

Nice work!

iarefluffy · 12-05-2015, 03:22 AM

Just finished installing my trunk with the tommy kaira wing and their 4th piece lip thing... @BRZtoni i did it buddy.

side note, never install a trunk by yourself. SHIT IS SO HARD. took me a good 2 and a half hours.

kev60625 · 12-05-2015, 10:36 AM

Quote:

Originally Posted by Choco

I went Christmas mode yesterday.

@miosaki @Vincenttam

Where can I get the nose for my car? Thanks!

BFIFE22 · 12-05-2015, 11:04 AM

Put on my Raceseng Sphereology shift knob. Loving it so far!

B-R-Z · 12-05-2015, 04:44 PM

Went to the Subaru dealership today to get replacement rear bumper brackets that broke when I was removing my rear bumper a while back to install my defuser.

At the parts desk in front of me is some younger dude asking the parts guy to sell him a Cobb AccessPort with the understanding that if he buys it there, he will be covered by warranty if anything bad happens. He then says if his motor blows, they would need to prove that the AccessPort was the cause to deny a warranty claim. Douche then says "but I only want this to get details about the engine that aren't provided in the dash information". The parts guy then tells him scenarios in the past that they have proved it was aftermarket parts or a bad install that was the cause which resulted in a warranty denial.

After he walked away, the parts guy rolled his eyes and took a deep breath and looked at me "How can I help you?"

Choco · 12-05-2015, 05:15 PM

Quote:

Originally Posted by kev60625

Where can I get the nose for my car? Thanks!

[ame="http://www.amazon.com/gp/product/B000XBGFO6"]Amazon.com: Mystic Industries Original Reindeer Vehicle Costume with Jingle Bells: Automotive[/ame]

DocWalt · 12-05-2015, 05:20 PM

Swapped in some Pentosin MTF2 in my trans. Last night I installed Diode Dynamics LED reverse lights. I'm not overly blown away by either.

The MTF2 seems to make the transmission feel more "mechanical" and like there's less fluid damping the shifting motion. It's definitely not worse than my stock gear oil, especially since the stock gear oil had a lot of metallic particles in it.

The LEDs are simply nowhere near as bright as I thought they would be and I went for the brightest ones that are sold. Oh well, still an improvement over stock.

Teseo · 12-05-2015, 05:23 PM

Quote:

Originally Posted by Spinning Sushi

A random bucket appeared and attacked my front lip on the freeway while I was doing about 65-ish...

Then I fixed it the next day with random stuff I had around.

Wheel info. Thanks

Choco · 12-05-2015, 05:32 PM

Added more rigidity to chassis!

Thank you @Apeks and @1GiantTurtle for the help and tools, also @thien for the tool box and those salty cookies.

go_a_way1 · 12-05-2015, 05:35 PM

Quote:

Originally Posted by Choco

Added more rigidity to chassis!

Thank you @Apeks and @1GiantTurtle for the help and tools, also @thien for the tool box and those salty cookies.

I have those on order! They look nice. How was the install??

Choco · 12-05-2015, 05:45 PM

Quote:

Originally Posted by go_a_way1

I have those on order! They look nice. How was the install??

The OEM screws on the chassis are on SUPER tight(this was the toughest part), it's pretty simple with proper tools, and even more easy with someone helping you hold the stabilizer in place while you put the new screws in.

go_a_way1 · 12-05-2015, 05:54 PM

Quote:

Originally Posted by Choco

The OEM screws on the chassis are on SUPER tight(this was the toughest part), it's pretty simple with proper tools, and even more easy with someone helping you hold the stabilizer in place while you put the new screws in.

Can I get away with a breaker bar?? Or should I use an impact gun?? I rather not set up the compressor as its in storage haha.

BRZtoni · 12-05-2015, 06:35 PM

Quote:

Originally Posted by iarefluffy

Just finished installing my trunk with the tommy kaira wing and their 4th piece lip thing... @BRZtoni i did it buddy.

side note, never install a trunk by yourself. SHIT IS SO HARD. took me a good 2 and a half hours.

true baller, i cant wait to see your car in person

CF mid section is always nice. i dont hav carbon parts thus no need for the extra baller $$$$

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Saw My First FR-S Today	Marrk	Scion FR-S / Toyota 86 GT86 General Forum	26	05-15-2013 01:40 PM
Got my new FR-S today.	Boosted2.0	Scion FR-S / Toyota 86 GT86 General Forum	51	06-03-2012 11:35 PM
Sat in a FRS today!!	Ladnerd	Scion FR-S / Toyota 86 GT86 General Forum	12	04-30-2012 02:48 PM
Got my VIN today...	Enemies	BRZ First-Gen (2012+) — General Topics	63	04-12-2012 11:19 PM
sat in a BRZ today	NESW20	BRZ First-Gen (2012+) — General Topics	8	03-31-2012 09:53 AM

12-05-2015, 05:20 PM	#13196
DocWalt Senior Member Join Date: Oct 2013 Drives: '22 BRZ Location: PA Posts: 1,949 Thanks: 2,428 Thanked 1,674 Times in 845 Posts Mentioned: 25 Post(s) Tagged: 2 Thread(s)	Swapped in some Pentosin MTF2 in my trans. Last night I installed Diode Dynamics LED reverse lights. I'm not overly blown away by either. The MTF2 seems to make the transmission feel more "mechanical" and like there's less fluid damping the shifting motion. It's definitely not worse than my stock gear oil, especially since the stock gear oil had a lot of metallic particles in it. The LEDs are simply nowhere near as bright as I thought they would be and I went for the brightest ones that are sold. Oh well, still an improvement over stock.

User Name		Remember Me?
Password