Jackson Racing Supercharger Owners Thread

[2ndgenhachi]

Got my kit installed this weekend! It feels prefect for my needs. Not overwhelming power but def not "under powered" anymore.

[surfuxalot]

hey does anyone have some dynos using the jackson racing complete kit (with factory tune), im on the fence with buying the jackson racing kit vs the vortech

Thanks

[LucidMomentum]

Originally Posted by surfuxalot

hey does anyone have some dynos using the jackson racing complete kit (with factory tune), im on the fence with buying the jackson racing kit vs the vortech

Thanks

First post:

Originally Posted by enivid

This thread is for owners of the Jackson Racing Supercharger.

Links:
Jackson Racing Product Page
Jackson Racing Supercharger Press Release and Info
Jackson Racing Rotrex Supercharger System Info and Discussion
Supercharger Comparison: Innovate, Jackson, Kraftwerks, Vortech

[CSG Mike]

Originally Posted by EN2_Squirrel

Ordered my kit earlier today. will the mishimoto kit oil cooler fit with it. I already have one(not installed due to 10month deploymnet). Google provides no leads... correct that i found this http://www.ft86club.com/forums/showthread.php?t=65715

while CSG Mike is a fountain of knowledge, it does not seem to answer my question

THe Mishimoto will not fit unless you get the universal kit and place it in front of the FMIC.

I would not recommend the Mishimoto at all; I've seen banjo bolts back out and cause fires more than a few times.

[surfuxalot]

Originally Posted by EN2_Squirrel

Ordered my kit earlier today. will the mishimoto kit oil cooler fit with it. I already have one(not installed due to 10month deploymnet). Google provides no leads... correct that i found this http://www.ft86club.com/forums/showthread.php?t=65715

while CSG Mike is a fountain of knowledge, it does not seem to answer my question

I saw this picture, but its with the vortech supercharger, idk about the JRSC...http://postimg.org/image/4wsz13tdb/20611171/

[CSG Mike]

Originally Posted by surfuxalot

I saw this picture, but its with the vortech supercharger, idk about the JRSC...http://postimg.org/image/4wsz13tdb/20611171/

Why would you mix a high quality JRSC with a low quality Mishimoto? Your car is only as good as the weakest point. After witnessing multiple oil fires, personally, on Mishimoto equipped cars, I cannot recommend you go that route.

[2ndgenhachi]

Help! Installed my kit and oil cooler. Ran fine died going to work. Sounds like fuel or spark. No cel. Advice?

[ScionOfHorus]

Originally Posted by 2ndgenhachi

Help! Installed my kit and oil cooler. Ran fine died going to work. Sounds like fuel or spark. No cel. Advice?

Check to make sure all hoses are clamped on correctly, check fluid levels, describe problem better.

[2ndgenhachi]

I started the car drove about 10 min and it does after a right turn. Fluid levels are good and all hoses I could reach from the bay r secure. Tried to start again and it's trying to turn over but will not start.

[CSG Mike]

Originally Posted by 2ndgenhachi

Help! Installed my kit and oil cooler. Ran fine died going to work. Sounds like fuel or spark. No cel. Advice?

Check your charge pipes. Did you clamp everything down?

[DaiTT500]

Sounds like a boost leak. It's a bitch to take off the bumper when the intercooler pipes pop off.

[2ndgenhachi]

Thanks for the direction everybody. It was kinda hard to think about where to look as I was freaking out. I'll double check all the hoses, pipes etc in the morning. Hopefully it'll be that simple of a solution

[dkstylezz]

Originally Posted by 264grendel

Has anyone received their backordered Ecutek kit yet, or have any update if Jackson Racing has sent them out?

Also just finished my install with their oil cooler and dual radium catch cans. Itching for that ecutek!

Dont know if this would help. I received an email stating my backordered EcuTek will arrive tomorrow around noon.

[Jackson Racing]

Originally Posted by 264grendel

Has anyone received their backordered Ecutek kit yet, or have any update if Jackson Racing has sent them out?

Also just finished my install with their oil cooler and dual radium catch cans. Itching for that ecutek!

Originally Posted by dkstylezz

Wondering the same too. EcuTek is all i need at the moment to get this started. JRSC and OIL cooler all came in last week. Any update or insight would be greatly appreciated Thank you!!

All of the EcuTek backorders were shipped yesterday. Depending on your location, you should receive them before the weekend.

-Oscar Jr.