Exhaust on a budget - Page 4 - Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community

904FRSlow · 06-29-2014, 02:12 AM

I ended up going with the Q300 and will save for other invidia products. I will keep the header stock for warranty purposes though

Sent from my SGH-T989 using Tapatalk

s2d4 · 06-29-2014, 02:19 AM

Quote:

Originally Posted by husker741

It's like he wants to be heard, but no one is listening.

Sorry to derail your thread, OP.

Says the person that derailed it.

Bobblehead · 06-29-2014, 09:51 AM

Quote:

Originally Posted by husker741

It's like he wants to be heard, but no one is listening.

Sorry to derail your thread, OP.

Quote:

Originally Posted by s2d4

Says the person that derailed it.

Fight nice guys. Were adults here, act like it.

Quote:

Originally Posted by 904FRSlow

I ended up going with the Q300 and will save for other invidia products. I will keep the header stock for warranty purposes though

Sent from my SGH-T989 using Tapatalk

Good choice. Some food for thought: You could get the Nameless front/over pipe combo and have a complete header back exhaust.

CatDaddysBBQ · 06-29-2014, 10:10 AM

If you want bigger tips, a little bit of sound but no drone and aren't pretending a cat back will give you any power, look into a works ab-m. 400 bucks, 10 min install, deep throaty growl but quiet for daily duty.

s2d4 · 06-29-2014, 10:11 AM

Quote:

Originally Posted by Bobblehead

Fight nice guys. Were adults here, act like it.

Good choice. Some food for thought: You could get the Nameless front/over pipe combo and have a complete header back exhaust.

Sure. Feel free to point out where I am lacking in evidence for making those calls.

WolfsFang · 06-29-2014, 12:39 PM

Make your own, boom, saved a ton of money.

Sent from my XT1060 using Tapatalk

SubieNubie · 06-29-2014, 01:53 PM

Quote:

Originally Posted by toeout

- $110 Magnaflow muffler

- $18 flange

- $52 muffler tip

- $50 labor for welding at the local muffler shop

Dual exit is about $20 more for the muffler + another muffler tip.

I really like this idea. I'm really surprised none of the typical exhaust retailers have created a single exit muffled axle back exhaust. I'd consider chopping up an OE one from another car if I knew what approximately what I was getting. IIRC our OE resonator is pretty hefty thus a change in a muffler makes little difference. I could be wrong though.

D_Thissen · 06-29-2014, 07:38 PM

Can't go wrong here http://www.ft86club.com/forums/showthread.php?t=68472

06-29-2014, 12:39 PM	#48
WolfsFang Scrape Master Join Date: Jun 2012 Drives: Goal: Oldest FRS State Side Location: North NJ Posts: 1,161 Thanks: 238 Thanked 412 Times in 238 Posts Mentioned: 10 Post(s)	Make your own, boom, saved a ton of money. Sent from my XT1060 using Tapatalk __________________ You do realize comparing the BRZ to the FR-S is like comparing which hand you love masterbating too right?

06-29-2014, 07:38 PM	#50
D_Thissen Senior Member Join Date: Jan 2014 Drives: '13 Argento FR-S (Sold) Location: Ontario Posts: 2,126 Thanks: 3,209 Thanked 1,439 Times in 855 Posts Mentioned: 19 Post(s)	Can't go wrong here http://www.ft86club.com/forums/showthread.php?t=68472 __________________ My FR-S Build IG: dthissen

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
best budget cat-back exhaust!	h4nh	Engine, Exhaust, Transmission	126	11-22-2016 02:33 AM
Ballin' on a budget - good lookin exhaust on the cheap!	Larkin	Cosmetic Modification (Interior/Exterior/Lighting)	8	09-05-2013 02:34 AM
$2,000-$2,500 Modification Budget	forzajuve	Engine, Exhaust, Transmission	60	05-07-2013 06:21 PM
$2K Budget. What Would You Do?	Skippman	Electronics \| Audio \| NAV \| Infotainment	46	02-22-2013 11:23 AM
There goes my MOD'ing Budget	RedRocket	Scion FR-S / Toyota 86 GT86 General Forum	35	10-19-2012 08:14 AM

06-29-2014, 02:12 AM	#43
904FRSlow Senior Member Join Date: May 2014 Drives: '13 FR-S Whiteout Location: Saint Augustine Posts: 304 Thanks: 39 Thanked 88 Times in 59 Posts Mentioned: 2 Post(s)	I ended up going with the Q300 and will save for other invidia products. I will keep the header stock for warranty purposes though Sent from my SGH-T989 using Tapatalk

User Name		Remember Me?
Password