WHAT DID YOU DO TO YOUR BRZ TODAY?

[JPxM0Dz]

Originally Posted by ichitaka05

I totally know what you mean. They're expensive too!

I might make DIY kit on this instead of $200 plastic... still debating

Yeah that would be awesome. Surprised somebody hasn't made a replica yet ??

[ichitaka05]

Originally Posted by JPxM0Dz

Yeah that would be awesome. Surprised somebody hasn't made a replica yet ??

I know right? This part is cheap to make & prob sell like hotcake!

[JPxM0Dz]

Originally Posted by DuMa

isnt that gap for drainage purposes so water can drain easily through there that gets blown from the wind?

Product Description

Product made by Toyota Racing Development to minimize the gap between the trunk and rear window. Airflow is greatly improved when using this part.



Features

• Reduce resistance by air
• Easy installation
• Installed using 3M double-sided tap
• Made from ABS

[DoomsdayJesus]

Originally Posted by JPxM0Dz

They are way overpriced for what they are, but I could not longer stand looking at that gap. I've seen them range from $189 to $240

Jesus Christ, what in the hell?

[unsurety]

Originally Posted by DoomsdayJesus

Jesus Christ, what in the hell?

Because TRD

[JPxM0Dz]

Finished modding my JP STi badges and installed

[chanomatik]

Originally Posted by JPxM0Dz

So much going on in this picture. I was actually considering the vortex generator, but wasn't sure how I'd accomplish it with the shark fin. I've also heavily considered shaving off the antenna, but now that I'm using my GPS unit more and will need it in the future, I guess I'm stuck with it. An antenna-deleted shark fin would be kinda cool.

[Simon99]

Spent my whole day looking for a fuel range estimate, couldnt fin it ; (

Sent from my SGH-I337M using Tapatalk

[BRZNutt]

Originally Posted by chanomatik

So much going on in this picture. I was actually considering the vortex generator, but wasn't sure how I'd accomplish it with the shark fin. I've also heavily considered shaving off the antenna, but now that I'm using my GPS unit more and will need it in the future, I guess I'm stuck with it. An antenna-deleted shark fin would be kinda cool.

Your GPS uses an antenna mounted under the dash. Roof mounted antenna is for satellite and AM/FM radio only.

[chanomatik]

Originally Posted by BRZNutt

Your GPS uses an antenna mounted under the dash. Roof mounted antenna is for satellite and AM/FM radio only.

Oooooohhhhh yeeaaaahhhh.... I should've remembered that since I had my dealer do the TSB where they adjusted the antenna to improve reception... Derp. Well I don't listen to the radio, so it looks like I can proceed with Operation: Antenna Shave. Thanks!

[JPxM0Dz]

Originally Posted by chanomatik

So much going on in this picture. I was actually considering the vortex generator, but wasn't sure how I'd accomplish it with the shark fin. I've also heavily considered shaving off the antenna, but now that I'm using my GPS unit more and will need it in the future, I guess I'm stuck with it. An antenna-deleted shark fin would be kinda cool.

Yeah I use have the Perrin shorty on there and decided to mod my beatsonic sharkfin to fit with the vortex generator. It actually looks quite good in person and quite happy with the results. I can see from the pics how it does look busy, but it's much better in person

[ntron1]

Originally Posted by Simon99

Spent my whole day looking for a fuel range estimate, couldnt fin it ; (

Sent from my SGH-I337M using Tapatalk

Click on any of these and you'll see a wide variety of of average miles between fill ups. My average range is about 460 miles to empty based on 35.0 mpg and 13.2 gallons available. That is if you can get 35.0 mpg and suck the tank dry.

http://www.fuelly.com/car/subaru/brz/2013

[Simon99]

460 miles ????? I'm having problems getting 460 km !

Sent from my SGH-I337M using Tapatalk

[Kotu100]

Originally Posted by FLYFISHR

Picked up my lip last night and was wondering where and how was the right way to install the two rubber strips that came with the lip. (a picture is worth a thousand words (fingers crossed)).
Thanks

I think this is what you're talking about. I put mine on the sides to keep the upper part of the bumper getting scratched over time from the rigid abs plastic.