|
||||||
| BRZ First-Gen (2012+) — General Topics All discussions about the first-gen Subaru BRZ coupe |
![]() |
|
|
Thread Tools | Search this Thread |
|
|
#6525 | |
|
Trust me, I'm the Doctor
Join Date: Nov 2013
Drives: 2019 WRX Limited (WRB)
Location: North East PA
Posts: 2,723
Thanks: 4,304
Thanked 1,252 Times in 782 Posts
Mentioned: 33 Post(s)
|
Quote:
Didn't see the truck this happened to, but the remains of his steel-belted radial were ALL OVER the road. This is one I managed to only partially dodge. If I'd just not done anything, I could have been waving bye-bye to a LOT more than just my front bumper's good looks, but to the radiator and condenser as well perhaps. I've dodged tire pieces plenty of times before. Usually someone else has struck them and then they land right around the painted lane lines, so only a little bit of a swerve is needed to avoid them then, OR, the tire utterly disintegrated and all that's left are little pieces that at most rattle around as they bounce up and strike the fiberglass undertray. Had to MASSIVELY swerve in the STI once to avoid a mattress that was just SITTING in the middle of a lane during heavy commuter traffic. My only warning then was the brake lights on the guy ahead of me and HIS swerve. Gave me enough of a heads up to duck into another lane. I've also had to dodge entire body panels just sitting in the road before (front and rear bumpers, mainly). Those are usually the result of a recent accident and the piece was simply knocked around by passing traffic too much for the cops to go looking for it when doing road cleanup. Enough bozos in this state drive around with parts of their car just missing or getting ready to fall off that it wants to make me scream. I'm now more than a bit envious of those bumper rails that are on all cop vehicles. One of THOSE would have shoved the tire piece right out of my way without the tire piece even mussing my front bumper.
__________________
Subies Of Blessed Memory: '05 Forester, '08 WRX, '13 STi
Daily Driver: 2014 BRZ 6MT Limited ^GT5 Replay Photo Mode^ |
|
|
|
|
| The Following 2 Users Say Thank You to SirBrass For This Useful Post: | chanomatik (03-11-2014), Turbo95eg6 (03-11-2014) |
|
|
#6526 | |
|
Senior Member
Join Date: Oct 2013
Drives: Subaru BRZ Limited
Location: New York
Posts: 410
Thanks: 161
Thanked 163 Times in 112 Posts
Mentioned: 2 Post(s)
|
Quote:
|
|
|
|
|
|
|
#6527 |
|
Go Big Red!!
Join Date: Jan 2014
Drives: 2013 SSM BRZ Limited
Location: TX
Posts: 515
Thanks: 489
Thanked 196 Times in 120 Posts
Mentioned: 11 Post(s)
|
Thanks! It should be around $750 for the bumper and hardware for it. Nothing else major was damaged thankfully. Last time they replaced all brackets and the bumper and painted it and it came out to $750 so it should come out to around there I would think since I'm dealing with the same guy.
|
|
|
|
| The Following User Says Thank You to Husker BRZ For This Useful Post: | chanomatik (03-11-2014) |
|
|
#6528 |
|
Sarcastic Bastard
Join Date: Apr 2013
Drives: '13 DGM BRZ, '13 Mini, 1999 Blazer
Location: Amish Land, PA
Posts: 586
Thanks: 341
Thanked 336 Times in 182 Posts
Mentioned: 3 Post(s)
|
Reacquainted myself with Redline as well as the Traction Control and Stability Control lights after a long cold winter.
|
|
|
|
|
|
#6529 | |
|
Senior Member
Join Date: Jan 2014
Drives: Subaru BRZ 2014 Limited WRB
Location: Atlanta
Posts: 268
Thanks: 112
Thanked 109 Times in 59 Posts
Mentioned: 3 Post(s)
|
Quote:
BTW, when you guys talk about replacing and painting the bumper, are you talking about bumper cover? or the moustache? -Z |
|
|
|
|
|
|
#6530 |
|
Go Big Red!!
Join Date: Jan 2014
Drives: 2013 SSM BRZ Limited
Location: TX
Posts: 515
Thanks: 489
Thanked 196 Times in 120 Posts
Mentioned: 11 Post(s)
|
I'm talking about the bumper cover, but as far as I know the moustache is part of the bumper. Someone correct me if I'm wrong, but last time I had the bumper replaced I unserstood from the advisor as it being one piece.
|
|
|
|
|
|
#6531 |
|
Snow Don't Hurt!
Join Date: Jul 2012
Drives: 2013 BRZ Limited 6MT CBS
Location: Anchorage, Alaska, USA
Posts: 2,538
Thanks: 6,416
Thanked 1,497 Times in 902 Posts
Mentioned: 42 Post(s)
|
It's one piece. You have to actually cut it out if you don't want it there. I'm also sure the rear diffuser is one piece with the rear bumper as well and requires cutting for removal. Silly Subaru... or CLEVER Subaru?
|
|
|
|
| The Following User Says Thank You to chanomatik For This Useful Post: | Husker BRZ (03-12-2014) |
|
|
#6532 |
|
Member
Join Date: Nov 2013
Drives: SWP BRZ 6MT
Location: SLC/UT
Posts: 15
Thanks: 5
Thanked 11 Times in 5 Posts
Mentioned: 0 Post(s)
|
I picked up some packages!
|
|
|
|
|
|
#6533 |
|
Member
Join Date: Jan 2014
Drives: Supra, BRZ
Location: LE,TX
Posts: 61
Thanks: 64
Thanked 21 Times in 15 Posts
Mentioned: 1 Post(s)
|
Picked up a Top Speed Auto full exhaust system. Installation starts tonight
__________________
1997 Toyota Supra TT 6MT - RR
2014 Subaru BRZ Limited 6MT - WRB |
|
|
|
| The Following User Says Thank You to trd87t For This Useful Post: | raven1231 (03-11-2014) |
|
|
#6534 |
|
Serial Cone Killer
Join Date: Jul 2013
Drives: '14 BRZ - WRB Premium 6MT
Location: Austin, TX
Posts: 1,326
Thanks: 1,081
Thanked 656 Times in 441 Posts
Mentioned: 19 Post(s)
|
Unfortunately I do not have that info, as it was graciously given to me by @trevorovert.
__________________
|
|
|
|
| The Following User Says Thank You to Turkish For This Useful Post: | 86-tundra (03-11-2014) |
|
|
#6535 |
|
GBS Mafia Member
Join Date: Apr 2013
Drives: with Snow mode on
Location: Costa Mesa
Posts: 541
Thanks: 338
Thanked 312 Times in 158 Posts
Mentioned: 8 Post(s)
|
Impromptu photo shoot outside of Santa Barbara Airport today... stopped by while running errands.
click here for more
__________________
![]() GBS Mafia |
|
|
|
| The Following User Says Thank You to KelvinBRZ For This Useful Post: | chanomatik (03-12-2014) |
|
|
#6536 |
|
Senior Member
Join Date: Nov 2013
Drives: 2014 BRZ SWP LTD
Location: The 503
Posts: 2,174
Thanks: 331
Thanked 2,266 Times in 858 Posts
Mentioned: 18 Post(s)
|
Ugh, I am having the biggest debate of getting it done... I don't want anything permanent on my car, and I love to wax. Looks great tho. Give me the secrets to your inspiration?
|
|
|
|
|
|
#6537 | ||
|
Senior Member
Join Date: Jul 2013
Drives: 2013 BRZ Limited WRB
Location: Ottawa, Canada
Posts: 1,278
Thanks: 375
Thanked 480 Times in 260 Posts
Mentioned: 29 Post(s)
|
Quote:
I believe Gtechniq might be for you ! Sent from my iPad using Tapatalk
__________________
Quote:
|
||
|
|
|
|
|
#6538 |
|
Troll Hunter
Join Date: Aug 2013
Drives: fr-s, tundra
Location: Somewhere
Posts: 1,424
Thanks: 1,695
Thanked 922 Times in 470 Posts
Mentioned: 39 Post(s)
|
ebay, like $65
__________________
|
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Saw My First FR-S Today | Marrk | Scion FR-S / Toyota 86 GT86 General Forum | 26 | 05-15-2013 12:40 PM |
| Got my new FR-S today. | Boosted2.0 | Scion FR-S / Toyota 86 GT86 General Forum | 51 | 06-03-2012 10:35 PM |
| Sat in a FRS today!! | Ladnerd | Scion FR-S / Toyota 86 GT86 General Forum | 12 | 04-30-2012 01:48 PM |
| Got my VIN today... | Enemies | BRZ First-Gen (2012+) — General Topics | 63 | 04-12-2012 10:19 PM |
| sat in a BRZ today | NESW20 | BRZ First-Gen (2012+) — General Topics | 8 | 03-31-2012 08:53 AM |