JNA Performance BRZ front lip review

[wlwarfield]

I recently purchased JNA Performance's Polyurethane C-Style front lip for the BRZ and figured I'd share the results and will answer any questions that one may have regarding the installation and/or fitment of this lip.

www.JNAperformance.com







Installation of this lip doesn't really come with any instructions, however, it is a pretty straight forward installation and can be done with the bumper on the car if you have an extra hand, or in my case, I opted to remove the bumper as I was doing the installation by myself. Instructions on removing bumper can be found here: http://www.ft86club.com/forums/showthread.php?t=8788



Included with the kit is 16 stainless steel washers and 16 stainless steel screws. The lip is pre drilled with holes so all you'll need to do is line up the lip to the bumper, grab the drill and affix the screws in the holes on the lip. Installation including bumper removal and re install took me 30-45 minutes from start to finish. (installation time may vary from person to person depending on skill level)

Difficulty Level: Easy
Fitment: 10/10
Quality: 10/10
Price: 10/10 ($99 + shipping)

Overall, I was very pleased with the quality and fitment of this lip. I did not have to use a heat gun or let it sit out in the sun or perform any other modifications to the lip before installation unlike some of the eBay or other cheap brand lips out there. I removed it from the box, lined it up, drilled holes/attached screws and was done with it.

[dito]

Originally Posted by wlwarfield

I recently purchased JNA Performance's Polyurethane C-Style front lip for the BRZ and figured I'd share the results and will answer any questions that one may have regarding the installation and/or fitment of this lip.

www.JNAperformance.com







Installation of this lip doesn't really come with any instructions, however, it is a pretty straight forward installation and can be done with the bumper on the car if you have an extra hand, or in my case, I opted to remove the bumper as I was doing the installation by myself. Instructions on removing bumper can be found here: http://www.ft86club.com/forums/showthread.php?t=8788



Included with the kit is 16 stainless steel washers and 16 stainless steel screws. The lip is pre drilled with holes so all you'll need to do is line up the lip to the bumper, grab the drill and affix the screws in the holes on the lip. Installation including bumper removal and re install took me 30-45 minutes from start to finish. (installation time may vary from person to person depending on skill level)

Difficulty Level: Easy
Fitment: 10/10
Quality: 10/10
Price: 10/10 ($99 + shipping)

Overall, I was very pleased with the quality and fitment of this lip. I did not have to use a heat gun or let it sit out in the sun or perform any other modifications to the lip before installation unlike some of the eBay or other cheap brand lips out there. I removed it from the box, lined it up, drilled holes/attached screws and was done with it.

thanks for the review, this was exactly what i was looking for. I was also looking at the hptmotorsports cs style front lip for the brz also but the price was pretty high for something thats gunna get scrape over time. good thing i found this! gunna order this! btw do you happen to have any pictures of the bottom of this lip to show where the screws are? i actually dont like the idea of drilling holes to my bumper so do you think some double sided 3m tape would do? thanks

[SkAsphalt]

^no, double sided tape won't do.