|
||||||
| Electronics | Audio | NAV | Infotainment Anything related to in-car electronics, navigation, and infotainment. |
![]() |
|
|
Thread Tools | Search this Thread |
|
|
#1 |
|
Boost Creep
Join Date: Oct 2015
Drives: 2016 HyperBlue BRZ
Location: Honolulu, HI
Posts: 604
Thanks: 281
Thanked 454 Times in 236 Posts
Mentioned: 10 Post(s)
Tagged: 2 Thread(s)
|
2016 Aftermarket HU - Stock Wiring
So I just tore open the dash to install my Pioneer HU and everything is connected but the door speakers don't work. Rear and dash tweeters and mids work great. I suspect there's a factory amp, but there is no wire in the #9 position of the 10-pin harness. The #8 position I have connected to the antenna turn on wire of the HU. I've also tested it with switched 12V to be sure. I'm not sure where to go from here.
|
|
|
|
|
|
#2 |
|
Senior Member
Join Date: Dec 2013
Drives: FRS
Location: Atlanta
Posts: 1,181
Thanks: 575
Thanked 291 Times in 216 Posts
Mentioned: 17 Post(s)
Tagged: 1 Thread(s)
|
make sure your remote out from the HU is wired to the harness that goes to the car to enable the stock amp.
__________________
|
|
|
|
|
|
#4 |
|
Member
Join Date: Sep 2015
Drives: 13 Sc10n FR-S
Location: Lancaster CA
Posts: 98
Thanks: 15
Thanked 38 Times in 29 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
Pin 9 should be the amp signal wire Don't know if it's a 5v signal though ![]() SC10N driver |
|
|
|
|
|
#6 |
|
Member
Join Date: Sep 2015
Drives: 13 Sc10n FR-S
Location: Lancaster CA
Posts: 98
Thanks: 15
Thanked 38 Times in 29 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
I personally just took the amp out and jumped the pins
SC10N driver
|
|
|
|
|
|
#7 |
|
Boost Creep
Join Date: Oct 2015
Drives: 2016 HyperBlue BRZ
Location: Honolulu, HI
Posts: 604
Thanks: 281
Thanked 454 Times in 236 Posts
Mentioned: 10 Post(s)
Tagged: 2 Thread(s)
|
I have that same manual, on the phone I'm posting from, in fact. It's apparently not fully applicable to this model year.
|
|
|
|
|
|
#8 |
|
Member
Join Date: Sep 2015
Drives: 13 Sc10n FR-S
Location: Lancaster CA
Posts: 98
Thanks: 15
Thanked 38 Times in 29 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
Wait your car is a 2016?
SC10N driver |
|
|
|
|
|
#9 |
|
Member
Join Date: Sep 2015
Drives: 13 Sc10n FR-S
Location: Lancaster CA
Posts: 98
Thanks: 15
Thanked 38 Times in 29 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
Then it's pin 9 of the extra connector that doesn't get used
![]() SC10N driver |
|
|
|
|
|
#10 |
|
Member
Join Date: Sep 2015
Drives: 13 Sc10n FR-S
Location: Lancaster CA
Posts: 98
Thanks: 15
Thanked 38 Times in 29 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
Sorry I was looking at the 2013 diagram for my car but it changes from connector "B" to "A" on the 2016
![]() SC10N driver |
|
|
|
|
|
#13 |
|
Member
Join Date: Sep 2015
Drives: 13 Sc10n FR-S
Location: Lancaster CA
Posts: 98
Thanks: 15
Thanked 38 Times in 29 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
Yup yup glad I could help, enjoy
SC10N driver |
|
|
|
|
|
#14 |
|
Junior Member
Join Date: Oct 2015
Drives: GT86 High
Location: Bergen, Norway
Posts: 9
Thanks: 0
Thanked 7 Times in 3 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
![]() |
What kind of manual is this?
|
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Using factory wiring for aftermarket fog light kits | Wizardhat | Cosmetic Modification (Interior/Exterior/Lighting) | 8 | 12-05-2021 05:05 PM |
| Aftermarket Headunit to Factory wiring harness? | Dadhawk | Electronics | Audio | NAV | Infotainment | 9 | 11-13-2015 12:23 PM |
| Stock amp/wiring questions | Matey | Electronics | Audio | NAV | Infotainment | 5 | 08-22-2015 09:28 AM |
| FRS aftermarket head unit installation - wiring | MindtheGap | Electronics | Audio | NAV | Infotainment | 35 | 01-14-2013 10:00 PM |
| P8400 Aftermarket deck HELP NEEDED WITH WIRING | iamkyle | Electronics | Audio | NAV | Infotainment | 1 | 01-13-2013 04:41 AM |