OFT Tuning Alerts Question

[RippedManiac]

Hi Everyone,

I recently went OFT stage 1.

I set a tuning alert for IAM less than 0.6 for I usually run 91.
Every time I enter the Realtime data mode, it beeps twice.

Im running V4 tune. Its supposed to start at .7 but the number usually climbs up to .8 - .9 which is good, but the first 2 beeps worry me.

I know its supposed to do a constant beeping sound if an alert is triggered.

Ive also seen my FLKC hit .7 and -1.4 but 0 KC learned. Not exactly sure what these mean.

Is this normal?
Pls and Thank you!

[dholloway543]

Mine beeps 2 times whenever i open the data monitor. I think its just the notification that the alert is turned on.


Then the screen flashes black every update until the perimeters set are exceeded then it flashes white every update. Probably to help grab your attention when your car is screaming and making lots of noise.

[tomm.brz]

KC learned is just a projection of a table called Knock correction A in Romraider.. don't care about it

those corrections are not so bad, you can maybe fix them by lowering 0,35 of ignition timing in that zone in the base timing B table