Quote:
Originally Posted by Hanakuso
Hmm interesting. People in the DIY are doing 1/2 for outlet and 11/32 to 3/8 for inlet. These sizes are for the tubing.
Im guessing bigger would be safer then smaller, but I rather get the sizing a close to OEM.
|
I have the D3PE catch can, and I'm sure it uses 1/2 for outlet (I clamped both) I'll check the inlet tonight. It might be 3/8" on the top of the throttle and 1/2" on the other side. I have no inlets as it vents to ATM, but I'm using the top of the throttle as my pressure signal for Gauge and BOV.