Toyota GR86, 86, FR-S and Subaru BRZ Forum & Owners Community - FT86CLUB - View Single Post - Borla UEL Header - Pics / Videos / Dynos - FT-86 SpeedFactory Review

ATL BRZ · 04-28-2013, 10:35 PM

Am I over reacting about the warping? Should I be willing to fix their mistakes for the third time myself?

I know it's minimal warping and it may seal up just fine, but should I just deal with it and accept a $730 MSRP product with defects even if they are minimal? How hard is it to put a straight edge on all the flanges to confirm flatness before shipping them?

I'm just over it and I'm ready to give up on Borla. There are better quality options out there and at this point I'm willing to pay more for them.

04-28-2013, 10:35 PM	#403
ATL BRZ TEQSPORT Brand Manager Join Date: Jun 2012 Drives: '24 GR86 + '16 FR-S Location: Atlanta Posts: 3,666 Thanks: 3,725 Thanked 4,137 Times in 1,707 Posts Mentioned: 90 Post(s) Tagged: 6 Thread(s)	Am I over reacting about the warping? Should I be willing to fix their mistakes for the third time myself? I know it's minimal warping and it may seal up just fine, but should I just deal with it and accept a $730 MSRP product with defects even if they are minimal? How hard is it to put a straight edge on all the flanges to confirm flatness before shipping them? I'm just over it and I'm ready to give up on Borla. There are better quality options out there and at this point I'm willing to pay more for them. __________________ ________________________________Toyota \| Lexus Parts & Performance Specialists__________________________________ Last edited by ATL BRZ; 05-03-2013 at 11:14 AM.