Quote:
Originally Posted by xcelir8brz
Sure as shit, I just checked the screws on top of airbox, and the upper left hand corner one was more than half way out due to vibration (and let me tell you I cranked down on them hard upon initial installation) and another one bottom right was a bit loose. Anyhow, I removed all screws on top lid, put a little bit of Loctite on all four of them and then screwed them back in as I originally had. I'm sure this will solve the problem. Now, I'm worried about the three holding the main air filter tube to the box! Didn't seem loose, but I also didn't remove the whole system to check.
|
FYI -
Took apart the system today. Accessed the three screws that hold the air filter assembly to the box, and used Loctite on them as well. Note: They were not loose, but better safe than sorry.