Quote:
Originally Posted by IsaiahW
Would i hear any grinding or chatter from the trans if i didnt set it properly? Im asking because i dont have any noise but i did the ole start in first gear with clutch applied but its as if the pressure plate is done or my adjustment could be off. I have a comp twin disk and tilton hydraulic release bearing everything is new. I forgot to note that this is a cd009 swap
Sent from my iPhone using Tapatalk
|
Quote:
Originally Posted by Ohio Enthusiast
As far as I know the Twins have a synchromesh reverse as well so would be no different than forward gears. Also, if you keep pushing the lever into a gear with the clutch not fully disengaged you'll grind regardless of synchros.
|
Not a lot we can probably do. Any guesses could be way off base since there are thousands of things that could go wrong with a swapped unit.