Quote:
Originally Posted by D-VO
@ steve99 - So today I was able to reflash for the factory MAP sensor and drive the car again: This time the car misfired at 6000RPM again, but I got a p0108 (Input Voltage to high at MAP) at the same time. Going for a new 4 bar MAP sensor, but I don't understand how a MAP sensor can go bad after an intercooler pipe blew off. |
Did you suck some steam up into the intake?
I blew a heater line on one of my cars and the steam it sucked it messed with all my air sensors since when the water evaporated it left a film of the additives all over them.