Quote:
Originally Posted by yash
Hey guys,
I installed a backup camera today on my 2013 FR-S 10 series, got it working until I somehow managed to break something with electrical and now my car won't start. It's not the battery (tried jump start) i've checked most of the fuses and they are ok. I haven't checked the relay and not sure how. I've recorded what's going on below.
Any help is much appreciated
Problem:
|
Hello yash and welcome to our group -
So, your car is an AT, are you sure the shifter is solidly in "park"?
What else, if anything, did you do the car around the same time you installed the back up camera?
I'd suggest you "review" what you did to install the camera, to see what might have gotten "unplugged".
You might check to make sure the ECU is screwed down tight.
Since the battery is turning the engine over good but it's not firing, it's most likely not getting fuel or spark (ya, I know daaaaaa).
OK, some other folks will be along soon, to - take er on in -
humfrz
(mumble-mumble, back in the 50s it would have been it was either out of gas or someone pulled the coil wire off)