Quote:
Originally Posted by venturaII
Gotcha. I'll use up my remaining Yamabond.  |
On the pan it's probably fine to use Yamabond but to be safe you may want to just buy TB1217H. It's about $19 on Amazon.
https://www.amazon.com/Three-Bond-Vi...gateway&sr=8-1
And while you are at it maybe buy this tool ($25):
https://www.amazon.com/Engine-Transm...gateway&sr=8-1
This tool has a sharp edge with a good surface to hit with a hammer and once hammered through the seal you can pull on the handle to pry the pan off. It gives more leverage than a screwdriver and a lot easier to hammer than a putty knife. Mainly due to clearance. If I recall the service manual recommends an SST that is almost identical.