Alright. So I kinda screwed up. I tried drifting for the first time and it didnt go too well. At first glance I could tell I bent my control arm. Upon further investigation my buddies and I found more stuff bent. Tie rod, trailing arm, and upper control arm + ball joint. Purchased those parts and installed them myself. When I took her to get an alignment, they found my subframe has been bent. See link below.
https://imgur.com/a/laXy0yo
What should I do to fix this last problem? The axels are fine and nothing else is messed up down there, except the subframe.
Would it be beneficial for me to unbend it myself with a torch and some hitting power? Replace the subframe myself? Or have it done by a shop?
Subframes are about $250 which isn't the cheapest but this is an expensive mistake that ive come to own up to. Any advice?