[xkalelx]

Step 8. Prep the carbon panel. Pull the panel out and place on a microfiber cloth upside down. Take rubbing alcohol and a lint free cloth and wipe down the bonding surface of the carbon panel. Then wipe down the roof frame bonding area on the car to ensure it is completely clean. Test fit the panel dry and when it is going to sit. Use a sharpie marker to make on the frame when you want the panel to end up. Try to make it even left to right and have equal over hang on front to rear. It wants to have about a ¼” of overhang in the front and back. Start prepping your hand clamps. You don’t want to start gluing without this already setup and ready to go.