Quote:
Originally Posted by Agent_D
Can anyone advise on ECUTek settings to get rid of the horrible dead zone in the first few cm of the accelerator pedal?
I've gotten used to the dead zone, but I still loathe it very much. I came to the BRZ from several previous RX-7's, and the DBW dead zone at light pedal inputs is extremely annoying.
Thanks for any information!
|
Straight after ecu reflash the fist part of accelerator pedal travel will be dull.
however this should disappear after a few drive cycles.
If it permanent you may have other problems like throttle pedal sensor or throttle body. or fueling problems.
Have you driven another brz/86 and is your much worse ?
You can remap the pedal input to output with ecutek, its under the basic racrom features. You could have 4 different pedal maps depending on the map mode your using ie 1,2,3,4 but you would need the racerom extension to edit this.
you should have access to map 1 accelerator mapping with basic ecutek kit, as long as your tune is unlocked or your self tuning.
ecutek maps pedal input percent to pedal output so you can re map it to say 10% input gives 20% output or whatever.
but I suspect you have other issues with tune or hardware