Quote:
Originally Posted by Brzzee
I noticed the 3.7 water-to-oil cooler is off the engine. Could you please post a picture of its rear (i.e. the mating surface between the cooler and its mount on the engine)?
I'd like to compare it to the 2012+ 5.0 Boss Mustang cooler kit I have on my bench for my BRZ oil system cooler project (2 qt accusump install, filter relocate, and cooler).
The Mustang cooler has water inlets that are bent as well as the block mounting flange has a 270 degree lip that protrudes from the mounting flange's surface. The straight inlet/outlet and a flat rear flange would make my life much easier.
Appreciate the help as I can find nothing on the Net that shows the rear of the cooler.
If it will be a better fit for my adapter, and you're not going to use it I'll buy it from you.
Thanks
|
My cooler flange looks just like the photos posted above. If you want it its yours. I did damage the center bolt thing as I didn't have an allen big enough, I bet you can just reuse yours.