[Ashikabi]

Originally Posted by Njjawn

My factory ducting is pretty much non existent at this point. Between plumbing for a sprintex hx and the custom splitter and chassis mounts, not much was saved lol.

Directing it more into the radiator should create a more positive flow of air through the rad, and a more pressurized airflow under hood. With proper hood venting, it should be very efficient. I think. I found the 3d model in 3d warehouse (sketchup database) for free! It isnt scaled, but I took measurements and made it to scale. There should be an FRS file in there as well.

Worked on it a little bit more. Widened the overall ducting to the width of the rad, leaving the center "diffused/directed" and the sides open. The top slits also direct up towards the top. I'll be honest, the sides/top are just to appear more aesthetically pleasing than a boring single piece duct.

Google SketchUp?

Sent from my XT1575 using Tapatalk