Quote:
Originally Posted by Ashikabi
This is an interesting project. My FRS already has a form of ducting/daming from the factory to keep air out of the fenders. Do you believe there will be any benefit to directing it even more into the radiator?
Also, where did you get your bumper model? Is there an FRS version?
|
My factory ducting is pretty much non existent at this point. Between plumbing for a sprintex hx and the custom splitter and chassis mounts, not much was saved lol.
Directing it more into the radiator should create a more positive flow of air through the rad, and a more pressurized airflow under hood. With proper hood venting, it should be very efficient. I think. I found the 3d model in 3d warehouse (sketchup database) for free! It isnt scaled, but I took measurements and made it to scale. There should be an FRS file in there as well.
Worked on it a little bit more. Widened the overall ducting to the width of the rad, leaving the center "diffused/directed" and the sides open. The top slits also direct up towards the top. I'll be honest, the sides/top are just to appear more aesthetically pleasing than a boring single piece duct.
