The service manual explains how to adjust the fluid level without any SST.
To drain and fill, you need:
Flat floor
BRZ service manual
Crush washers for drain hole
Some way of funnelling ATF in to the fill hole
Drip tray
Wire
Patience
That will replace about 1/8 of the fluid.
If you want to replace it all, you need to go to a reputable transmission shop that can pump fluid through the entire transmission including the torque converter without fucking the valve body, etc.
Quote:
Originally Posted by euthqt
Hey guys.
So I'm planning on changing my ATF for my FRS here soon. I'm planning on using Redline D6 fluids. Now, I want to do this myself, but after doing research and reading over the instructions a few times, I'm feeling a bit concerned.
The instructions state to bring the transmission fluid temp to around 42c at certain points. Being as I don't have a Toyota diagnosis tool, how would I go about doing this correctly, or do I have to bite the bullet and let a dealer do it? :eek:
If anyone has tips, instructions, or lessons learned, I appreciate it!
Thanks guys.
|