Quote:
Originally Posted by D18
On a slightly separate topic, when adjusting the rear end links on the ground, I find that the neutral setting results in the end links being a significantly different length. I haven't measured, but it could be close to 1 cm. Is this normal?
|
Quote:
Originally Posted by OkieSnuffBox
Yep, that's the point. Bring the bar back to horizontal (or as close as you can) and eliminate any preload one direction or the other.
|
Why not even them out? If you have 1 cm difference, shorten the longer one by 0.5 cm and make the other 0.5 cm longer.
Quote:
Originally Posted by Mindsucker
Did you install the endlinks with the car on the ground?
|
Quote:
Originally Posted by Kellhound
I'll purchase some ramps today and adjust the Whiteline links with load on the chassis. I really hope this works.
|
If you have access to two jacks, it's much easier to do it with the wheels off. Keep the car on jack stands. Then put a jack under each upright (hub) and lift the car both sides just enough till the suspension compresses and and you take the load off the jack stands.