Quote:
Originally Posted by Astroboy
How do you change them? You just need to remove the wheel and replace them from the back correct without removing the hub correct? Never really looked black there so Idk. I'm more worried about that bent jack point! I how it doesn't bend this week while it's on the lift when I'm replacing the clutch this week and kill me...
Sent from my LG-D850 using Tapatalk
|
Google never hurt either. It kinda sucks, the tools mentioned in the thread below mean you should be able to do everything in your garage, even with hand tools the only special things I needed was a spare jackstand and a vice meant I could pull the studs through with hand tools instead of an impact driver but getting them pressed in the right way is easier.
http://www.ft86club.com/forums/showthread.php?t=21563
You need to remove the rear hub to install the long studs, I think you might be able to do the short studs with the hub in place, kinda sucks but not impossible to do.