Quote:
Originally Posted by SDP
It is the original as far as I know. It says flash complete and 1 dtc read, I clear it and after that it shows 5 dtc' cleared and shows as follows:
UO122
UO131
UO100
UO122
UO131
And says they cleared. But if I run a dtc check only UO100 cleared. As far as not coming out of programming mode...from what I've read that when you flash the ECU, it turns off all other ECM's and such, which it has done, problem is it doesn't turn them back on after I'm done! May just need to be something Perrin and I work with Ecutek to figure out.
|
Check battery volts
check fuses
check any plugs socket wiring you touched or moved
remove battery cable then press brake pedal leave for five minutes then reconnect, check both battery terminals and earth connections.
sounds like somthing on CAN bus is not happy it might be just one module effecting communication on the buss
if you have techstream run can buss diagnostics
pretty sure techsstream will work with ecutek cables