Quote:
Originally Posted by jdp530
Can units of measure for speed or temps be changed after tests have been run? I have all the units set up on Race Studio the way I want them but I see that units of measure after event yesterday are different. So I am wondering if I can change them in the RS2Analysis program. Thanks,
|
Unfortunately, no. The Solo DL is taking the raw output from CANBUS, interpreting it (converting it) into the unit of your choice, and then recording that interpreted number.
You *can* open the file raw and run a macro to change the units, but you're probably better off printing out a quick conversion table for the units you're trying to convert, when you're looking at data.
When you do the device configuration, make sure you set everything the way you want (units, decimal places, etc.), and then upload it to the Solo DL. Make sure you pull your data from the unit first, as reconfiguring wipes the unit!