Managed to get myself a PLM overpipe supplied by FT-86SpeedFactory,
(63mm/
2.5inches Outer Diameter with an inner Diameter of 60.5mm)
Feels really light and solid (Good quality),
Looking forward to installing it with:
Borla UEL(v2) Headers (58mm/2.25inchs Outer Diameter)
+ Catless Front pipe (63mm/
2.5inches Outer Diameter)
+ Cat back (63mm/
2.5inches Outer Diameter)
I decided on this overpipe based on the following:
1)
Sizing
(Outer Diameter of 2.5inchs to complement my front pipe and catback)
2)
Affordability
(Approx $195, as opposed to similar sized overpipes which go for +$300)
3)
Build quality
(Its not the best, but its decent, lightweight, handmade and TIG welded)
Hoping to get maximum aggressive rumble /
sound quality from the exhaust set-up.
(Not expecting any significant increase in power)
Thanks @
Anthony for the information shared and your advice on my specific questions on your Youtube Channel
