Quote:
Originally Posted by autograph
I bought the following reverse light: http://store.ijdmtoy.com/Valenti-Sty...tion-a/617.htm
the instructions say to install the reverse light just like you uninstalled the stock reverse light. on top of the stock reverse light, there are two bolts. However, when I went to put the bolts into the new reverse light, nothing was catching -- as if there is no thread-hole at all. All that is holding it currently are the two side plastic screws and the plastic clip on the middle/bottom. Not sure if this is safe. Anyone with these reverse lights care to input?
Thanks! |
If I remember correctly I pulled the factory metal tabs off of my stock 3rd break light and slid them onto the Valenti ones so you could use the bolts up top