Quote:
Originally Posted by lookchris
I have a 2013 Limited BRZ and was wondering if any of you guys w/ push to start have problems starting your car after the flash? I'm just running the stage one flash
|
Yep have one of those no problems yet.
Follow direction on OFT (or flash software) after flash is completed turn car completely off.
Then turn on (don't touch accelerator),wait about 20 sec, should start straight up, let it idle for a minute or two (no throttle), then your good to go.
see here
http://www.ft86club.com/forums/showthread.php?t=68328
if your LTFT are large it might be worth scaling MAF, shortens up fuel trim learning process after flash or reset also get smoother drive and AFR closer to those set in OL Fuel tables.
http://www.ft86club.com/forums/showthread.php?t=64790