Quote:
Originally Posted by brenesk91
I'm not sure if anyones seen this yet but I came across it while lurking on instagram looks pretty badass, twin turbo set up if anyone wants to look him up on instagram his name is madman5446
 |
I made so many jokes about doing sequential turbos.... lol. And now someone goes and does a twin setup.
Quote:
Originally Posted by SirBrass
Yeah that sucker isn't complete & he's already out of room. No place for intake filters at all. So he's going to run unfiltered air into a bared compression wheel?
Sent from my SCH-I535 using Tapatalk
|
#becauseracecar
I actually did this many years ago... put like 10k on a turbo setup with a mesh. Meh. No I wouldn't recommend it... but... haha The best part was everyone always said "What if it rains"... Nothing... nothing happens. lol
Also I see a ton of room for intakes.
There is a perfectly good piece of metal to cut through right there... And no I am not kidding. Just weld in a pipe for reinforcement if you are worried about strength post-cut. You can also 3d print / inject an odd shaped intake to push them more forward and get them behind the fake brake vents / fog whole.
If you think about it he is keeping the boxer idea in place, low mount turbo... low center of gravity... symmetrical weight. HAHA!