[digital_assassin]

So I spent some time looking things over and cleaning it up to see what really needs to happen. Tomorrow night I'll test fit it on the car and see how the panel joints line up.


Going to need a lot of sanding due to the gel coat finish being uneven and then fill in some minor cracking of the gel coat in spots. Also going to need to fill in the holes that were created by PRE in an attempt to get the factory bezels to line up. Should be a fun project. It will turn out good, I'm sure of it.

And I also bought the brake ducts and backing plates. These look amazing. I'm a sucker for dry carbon. To bad these will be buried behind the rotors.