Quote:
Originally Posted by Urmyson
I have a Unichip and been running Torque. The other day i found the Knock Detector add-on and tried it out. It almost always said possible knock detected. It's usually -.05 correction out of 15-20 samples(about 10 secs of WOT). Is this normally or should i run a map to reduce the timing? I don't know if the app is reliable or if i shouldn't worry about it.
Thanks,
Joe
|
If you're only getting 15-20 samples in 10 seconds of logging, your interface is way too slow and you're not logging useful information.