View Single Post
Old 10-17-2013, 09:13 AM   #23
calispec
Senior Member
 
calispec's Avatar
 
Join Date: May 2013
Drives: Subaru BRZ with Delicious Innovate
Location: Cleveland OH
Posts: 194
Thanks: 81
Thanked 106 Times in 63 Posts
Mentioned: 10 Post(s)
Tagged: 0 Thread(s)
Garage
Quote:
Originally Posted by Jay_viper View Post
Hello all I'm new here and I don't own brz or fr-s but I do think they are a very nice vehicle inside and out. I am also a Autotech with Best buy and I was searching threads the past couple of weeks to find information about doing a viper 5904 on a 2013 brz limited push to start manual trans. as I had an Install set up for one this past week. I'll tell you that there is not a lot of info on this car for adding aftermarket Remote start. Well after doing some research and physically looking at the vehicles wiring I got the viper 5904 Installed and fully functional. I will tell you the dei tech documents for this vehicle are missing some info. I did have to use the dei 1101t but there was a little more to it to get it to work(4 extra relays and 9 diodes). The wiring info was a little off but was easy enough to figure out. While doing research I came across this post and wanted to know has anyone else has done a viper remote start on a brz limited with the PTS and manual trans.? If so any issues that you ran into so far? Well I'll also be checking in to see what you all say.
When you use the 1101t and the car is started, if someone were to get into the car somehow what would keep them from just driving away? If you start the car, get out and leave your keys in the house the car works fine until you get to your destination and can't start your car again. I am a few weeks from attempting a smart start. I was an AutoTech as well.
calispec is offline   Reply With Quote