View Single Post
Old 10-04-2013, 03:41 PM   #63
mitosis
Member
 
mitosis's Avatar
 
Join Date: Aug 2013
Drives: 2013 FR-S, 2008 Fit
Location: Near Sacramento, CA
Posts: 77
Thanks: 219
Thanked 65 Times in 30 Posts
Mentioned: 5 Post(s)
Tagged: 0 Thread(s)
Quote:
Originally Posted by strat61caster View Post
...regularly log those stats...
Nah, those just happened to be days that I remembered to connect up my phone and run Torque when I got into the car in the morning. I have Torque set up to just always log everything if it's running but I almost never actually look at the logs unless I was out for a fun drive and I want to check what my peak temps were at.

Back in August when there were all those logs on almost every morning for a few days there it was because I had just picked up the OBD II dongle and I was trying to answer the exact same question that was brought up in this thread of how long it takes to warm up and I was looking for a baseline. After that I only logged once in September and then again this morning because it was for SCIENCE!!!

I guess I am a bit strange though...

Quote:
Originally Posted by getbent View Post
Just food for thought for the folks without oil pressure gauges ... anything over 2000 rpm when the engine is cold (relative of course 70-80f) results in the oil pump going into full bypass (>=125 psi). I typically keep the revs to where the oil pressure is <120 psi while warming up.
Oh man I gotta get me one of those!
mitosis is offline   Reply With Quote
The Following User Says Thank You to mitosis For This Useful Post:
strat61caster (10-04-2013)