Work Equip wheels 19''- 10.5j -6 off set
 

Hi
can anyone help me regarding wheel fitment on FRS stock body
i am planning for work equip 19'' with 9j +22 front and 10.5j -6 rear..with HKS hypermax IV GT coilovers
Suggest tires and other stuff if required to fit above setup perfectly

Welcome to the forum Cuztomizer

http://www.ft86club.com/forums/showthread.php?t=24694. This link has an aggressive setup. I'd check out how they accomplished it... Good luck!


Edit: Whoa! -6 rear offset stock body! I'm not sure that will fit...

I think he missed will this fit rocket bunny kit?

1st post..., gotta be rocket bunny!

Dont want to go with rocket bunny
Is thr any way out?

I am not an expert. But understand the numbers. Your back wheels are the same width. The offset will push the wheel out an additional 23mm, and require more camber. -6 is already extreme. (yes, in my opinion) I can see the fronts "fitting" but your rear Wheels are going to be difficult. (or impossible)

Here is another thread to read through. http://www.ft86club.com/forums/showthread.php?t=39548