OFT: Launch control and Flat-Foot Shift for F00C ROMs ready to test
 

Hi guys,
Any OFT user with the new F00C calibration ID want to test Launch Control and Flat-Foot Shift? If so, please email me at shiv@openflashperformance.com and I can send you a tune file to test :)

Cheers,
shiv

I can get D00G guys to test also. Haven't had time to try to patch it over from D00C.

What do you recommend the FFS delta be set to?

I put mine at 7000 rpm's, it works great.

If you set delta to 7000 then FFS would activate at 600rpm ??



Try FFS delta of about 2000

LC delta say 3600



Adjusting/Activating Launch control and Flat Foot (no lift) Shift parameters

http://www.ft86club.com/forums/showt...launch+control (Only for Manual vehicles)Note : OFT ROM's have a special patch for these functions use the definition files from the www.openflashtablet.com website downloads page

Launch Control -LC
Basically a second RPM limiter that is active when the vehicle speed is below the threshold speed set regardless of clutch in/out.
Launch control Disable speed = speed at which Launch RPM is disabled (ie you revert to normal red-line RPM limit 7600) default = 6mph (aprox 10KmH)
Launch Control RPM Delta = Amount to subtract from your Red-line RPM to get you Launch RPM e.g. if LC RPM Delta = 3600 your Launch RPM will be 7600-3600 = 4000 RPM

To disable Launch Control set LC RPM Delta = 0

Flat Foot (no lift) Shift -FFS
Is Another RPM limit activated when the Clutch is depressed (it does not monitor that the throttle is flat or 100%) for this reason it can activate on downshift.
Flat Foot Shift RPM Delta = Amount to subtract from your Normal Red-line RPM to get FFS RPM limit eg if you set FFS Delta = 2000 your FFS RPM limit will be 7600-2000= 5600 RPM so when up-shifting with foot on accelerator RPM will be limited to 5600 RPM as soon as you depress clutch even though your foot is on accelerator. Note its does not need the accelerator/throttle to be 100% or flat to activate its activated of Clutch switch only. This can sometimes cause issues on downshifts if you set the RPM to low for Flat foot shift.

To disable FFS set Delta to 0 (zero) in the table FFS RPM Delta using Romraider

I said 7000 rpm's not 7000. FFS is at 500. It works great for me.

I think the LC Delta that I set up is around 3400-3600.

What happens if you set the speed at a much higher amount?
Will it use a 4000 rpm redline until you reach the specific speed?

Yes the LC rpm limit will be active till the LC disable speed is exceeded so if you set LC disable speed to 20mph the car wont rev over the LC rpm limit till vehicle speed exceeded 20 mph

I'm guessing this is why my OFT won't work with my 2016 Z12JF00C car! Tune files aren't released yet!

Any sense of when tune file/definitions will be available for new 2016 F40C calibration ID? @Shiv@Openflash

If somebody sends me the rom, I'll define it.

Definitions are done - up on Romraider and I've sent through to Shiv as well (and ported LC / FFS)

http://www.romraider.com/forum/viewt...p?f=34&t=12467

If you could send me the new stock roms ill add them to the tactrix post