Full blown turbo kit, boosted issue. Help please
 

Alrighty so apparently my map sensor is having issues with the new kit. Map, it's reading that the barometric pressure is too high. And at about 5k it basically shuts down. So I can't play with it.

May have better luck asking that here:
http://www.ft86club.com/forums/forumdisplay.php?f=78

what tune are you running?

The full blown base map.

you might want to consider getting a custom tune. the base map literally is only used to get you to a tuner.

Stock MAP on a Speed Density tune? Sounds like a base map for you to get an actual tune.

You'll need a different MAP as well. Consult with FB or your local tuner for recommendations.

Or... get the 4bar map sensor from FBM. The stock map sensor isn't going to do you justice. I'm running the base map with their 4bar and it runs like a champ. A/r is on key.

As I mentioned on Facebook my guess is that you have a tune for an aftermarket MAP sensor instead of the OEM MAP sensor. The car should run just fine on a Full Blown MAP sensor and OEM MAP sensor if you have the right tune. It has been over 2 years since I ran the Full Blown basemap, but it wasn't speed density at the time.