San Diego Lowering Springs Install
 

Hi, I was wondering if anyone knew a good place to get my Eibach Pro lowering springs installed. I can't really do it myself because I don't have the tools and I don't have friends who know how nor have tools as well lol.

I'm located in San Diego, if anyone knows a place or someone who's familiar with the twins that would be much appreciated.

You could always head down to harbor freight and it would probably cost you less than a 100 bucks for everything you need. Most of the cost would be the jack and stands. If your not too mechanically inclined there are a few DIY on here for lowering spring install. Just make sure you don't spin the shaft while loosening the top nut. Just use an Allen key to hold it in place while you loosen the nut. Sorry I'm in la county so I can't really help you. If you can't seem to find the link for the DIY pm me and I'll help you locate it. Good luck

Thanks a lot man, I'll look into that. If I'm not too retarded I'll most likely end up doing it myself lol.

@Infamous Performance

Thanks for the info! I tried calling twice, but it seems like they're busy. I'll give them another call again when i receive my springs this Friday. If not I might go the DIY route.