So how do you fix this? SPC LCA with Stance coilovers
 

http://i.imgur.com/OLoIgap.jpg

So I had initially installed the SPC rear LCA and Stance coilovers with success. I went to adjust the ride height in the rear and started to unbolt the hub, sway bar and strut. Adjusted the rear ride height to where I wanted it and now I can't get the rear LCA to line up to the Hub at all. Spent a few hours trying different combinations on getting it aligned properly and it just wasn't working out. I even took the coilover off completely to see if that what was causing the issue and I couldn't get the LCA to line up. Any help or ideas appreciated. I'm hoping it's something simple I'm overlooking. Thanks.

This happened to me after I installed my Cusco LCA's. I used a pry bar and a jack to help move it around. I had to pry and pull pretty hard then I bolted up the hub. I then jacked up the hub some more to get the coilover in.

Jack up the arm. Use a thick screwdriver and put it through. Make sure you use a piece of wood so you don't damage the arm.