Cutting Stock Exhaust Into Single Exit?
 

Had a random thought today. If I were to cut the stock exhaust and weld on a pipe making it look similar to the Nameless or Berk Track Pipe exhaust, would the tone be the same? It'll basically be the same shape and size..

Yea it will sound the same since you are deleting mufflers. The Berk muffler delete I have is 2.5 inches..the factory iirc is 2.25..so diameter will be off by .25 inches.

http://blogperrinperformance.com/wp-...st-diagram.jpg
You wanna cut behind the muffler? Basically run straight after the mid pipe?

I wanna cut like right at that little curved piece right before the muffler starts, so the on the pipe after the midpipe before it goes into the muffler itself.

Think that would make it deeper or less?

It would be a muffler delete. Just google Berk muffler delete.

I'm aware of that, did you read my initial post? Haha I'm asking if I cut it instead of buying the Berk, would it be the same.

[ame]http://youtu.be/diHcsp47Emw[/ame] . Here is my car with just a muffler delete to give you an idea.

Thanks!