winjet led wiring to factory led fog strip?
 

So, my question is:
I have the factory led strip fog lights. Which has the strips on ea each side, a controller located under the dash, and a switch on the dash. I recently acquired a pair of winjet head lights and was thinking I could power the boomerangs with the fogs. So they run the same sequences (full on-head light off, dim head light on). Would I need to tap the winjets before the controller or after? Do the winjets have a built in controller?

That actually doesn't seem like a bad idea. I don't know how the winjets are wired, but I would just run the positive for the LED strip on the winjets, and tap into the positive for the led strip below it. Ground on the factory headlight connector. Should be pretty simple.