Genome Tuning Carbon Fiber Splitter
 

Hey guys we are working on a new splitter for the FRS/BRZ platform. We are aiming for a price point of $380 including all the hardware and support rods (provided by APR) as well as a template for drilling locations. We will be doing a Group Buy for the first 10 at $340 shipped! Will release info very soon :)

Here is a picture of it installed what do you guys think?

Nice, and a halfway decent price too......I'm in.

Neat! What's it made from? What do the supports connect to? It won't bend, right?

where is this made? material?

The splitter is made from carbon fiber with a fiberglass bottom to take the beating from scraps. The support rods can attach to the chassis, but we have it attached to the grill and had no bending issues. Also the support rods we used are APR rods. :)

This is made in California, USA!

Does this splitter replace or cover all the under-plastic pieces that are held on with push clips?

My front end, like many others, is not lining up properly at the bumper/fender junction, and I think this is partly because when the shop installed my turbo kit, they took ALL the front end pieces off, and IME they never go back exactly how they're supposed to, and this is causing misalignment of my bumper and front inner plastic wheel well.

I'd like to remove all that crap and just run a splitter like this.

Would like to see a couple more pics, but very interested

Looks good, you guys have a release date yet?

$300 shipped? If so, I'm in.

I see you updated to $340..

More pictures? Is it pre drilled? Hardware?

Yup $300 is before shipping and $340 is shipped! If you want to pick it up for the first 10 sets I can do $300. It comes with all the hardware and APR rods. It is not pre-drilled but it will be marked with holes for recommended drill points.

Any more info on this? I'm interested in picking these up. So they're rebranded apr splitters?

In for more info as well. I could pickup.

Hey guys what kind of information are you looking for? The splitter is manufactured and designed in southern california with high quality material. We are utilizing the APR splitter rods as part of the hardware kit, rather than use some cheap ebay splitter rods. The splitter covers majority of the bottom of the bumper, however there is a cut in the middle to allow for one of the center panels to fit without being removed. If you guys have any questions feel free to ask me! We are doing a GB and can provide local pick up, email me to be added to the list :)