AC Vent Trim plasti dip
 

can someone please help me here.. I want to plasti dip this piece..how do you guys take it out???

http://www.ft86speedfactory.com/imag...ac_trim-28.jpg

Squeezing it will allow a bit of room to stick something in to pop it out. You can use a flat-head but be careful in scratching or use a rubber removal tool.

clear me here plz, Squeezing the rubber part behind the ring the pry it out???

Like using the thumb and index finger on opposite sides of the ring (like at the top and at the bottom) squeeze and it should open a small gap.

It's kinda hard to explain but if you just fiddle around you'll be able to get it.

ok.. gonna try it tonight.. thanks man

You may want to do the door handle trim as well. That one has a slot at the very bottom for a flat-head. You can tape the tip to avoid damage.

Stick a screwdriver in the 1 o clock position. If I remember correctly, there are 3 tabs at the 11, 2, and 6 o clock positions. It doesnt take much to pop it off.

try using a credit card

idk how i did it, but when i used a screw driving to take mine off, its made an indent on the plastic,

barely used any force when i did it too

Yes man..I already did the door handle over the weekend. now try to work on AV vent ones.